Add to Cart:

P-FS-FS02 Car Failsafe (Intelligent)

€13.00
Sale: €9.75
Save: 25% off

Failsafe unit moves the throttle servo to a setting predetermined by the end user and operate on total loss of signal, strong interference to the radio signal and also if the receiver battery goes flat. It is highly recommended that all IC aircrfat and IC cars are fitted with a throttle failsafe.
  • Operates on 4.8V and 6.0V
  • FS-FS01 Failsafe (Intelligent)

    FS-FS02 Car Failsafe (Intelligent)

    These simple to use failsafe units will operate on total loss of signal, strong interference to the

    radio signal and also in the event of you receiver battery going flat.

    Plug the failsafe into the receiver channel that you have selected and then plug the servo that is

    being used onto the output pins on the failsafe ensuring the correct polarity with the markings on

    the failsafe label (+ Positive, - Negative and SI Signal ).

    Turn on the radio and move the servo with the failsafe fitted, to the position you want it to go to

    in the event of interference or loss of signal. Press and hold the switch on the failsafe until the red

    LED lights up, then release the switch and the LED should flash a minimum of three times to

    confirm the position has been memorised.

    Check that the failsafe set up has been successful by turning off the radio to check that the servo

    moves to the position you set the failsafe at. If it doesn’t, go through the set up procedure again.

    Once the failsafe has been set up, the position has been memorised and will not need to be

    repeated until you want to reset it to a new position.


    Add to Cart:

    • Manufactured by: Fusion


    Additional Images


    Copyright © 2017 dmaxrcmodels. Site by Aura Internet | Site Map